08-31-2009 05:17 AM
Hi Team
when i am trying to access the swich though SSH, its getting failed, Plse find the attached screenshot for the same.
Even we are able to SSH from Putty.
LMS 2.6
Regards
Vaibhav
08-31-2009 05:33 AM
Please verify configuration fetch protocol and package version.
Hope this helps.
Regards.
Andrea
08-31-2009 08:26 AM
This shows nothing about SSH. It looks like you ran a Device Credential Verification job, and only selected telnet. Re-run the job, and choose SSH, and Enable by SSH, and see if that works.
08-31-2009 09:21 AM
Hi Clark
where we need to choose SSH and where to enable SSH to get access of device only through SSH.
Regards
Vaibhav
08-31-2009 09:52 AM
You choose the protocols to test when creating the Device Credential Verification job. There will be a series of checkboxes.
To make sure RME only uses SSH, you have to set your protocol orders accordingly under RME > Admin > Config Mgmt > Transport Settings.
09-01-2009 04:46 AM
Hi Clark
We can do that but let me know if on other devices where ssh not configured than weather we are able to add them or not.
Regards
Vaibhav
09-01-2009 08:14 AM
If you need to support other protocols, add them to the protocol order lists after SSH. That way, SSH will be tried first, and if it fails, then RME will fall back to other protocols.
09-01-2009 11:50 PM
Hi Clark
Thanks a lot..
Regards
Vaibhav
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: