cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
499
Views
0
Helpful
2
Replies

Problem with a device in DFM

rnieuwhof
Level 1
Level 1

I have 28xx router in DFM it is being monitored for it's WAN and uplink interfaces. ALL other interfaces have been set to false in the detailed device view, as we have an ISDN PRI for CCME installed on this router. The PRI interfaces have been set to false NUMEROUS times, but are getting set back to true for no apparent reason. What could cause them to be reset to true?

DFM is 3.1.3

CS is 3.2.0

CM is 5.1.3

RME is 4.2.0

Thanks,

Rob

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

This is bug CSCsz08953. A patch is available from the TAC for DFM 3.1.3.

View solution in original post

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

This is bug CSCsz08953. A patch is available from the TAC for DFM 3.1.3.

Thanks Joe!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: