UC500 and failover connection

Unanswered Question
Sep 2nd, 2009

I have a UC500 & ASA5505. Both systems were in place and working when I took over the site. I'm more familiar with ASA, and I've been tweaking that.

I have route tracking setup on the ASA with a T1 (primary 'outside') and DSL (secondary 'backup').

When the T1 goes down, the DSL route is automatically injected as the default route. I'm still very new to CME, so how would I accomplish minimal downtime on the UC500?

The last time we had an outage, the computers were all online fine, but the VoIP system was down.

Where do I begin?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion