Show Commands in 1131 AG AP

Unanswered Question
Sep 2nd, 2009

hi experts,

i would like to know how to verify using show commands in CLI if 1131AG AP radio is working and if clients are associating on AP

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
rob.huffman Thu, 09/03/2009 - 05:29

Hi John,

show dot11 associations

[client | repeater | statistics | H.H.H | bss-only | all-client | cckm-statistics]

This example shows how to display all client devices associated with the access point:

AP# show dot11 associations client

show controllers dot11radio

Use the show controllers dot11radio privileged EXEC command to display the radio controller status.

show controllers dot11radio interface-number

Syntax Description


Specifies the radio interface number. The 2.4-GHz radio is radio 0. The 5-GHz radio is radio 1.

Hope this helps!


Leo Laohoo Thu, 09/03/2009 - 15:43

In addtion to Rob's post (+5), I would also add show dot11 associations stat. This will give you a reading of the number of successful authentication since last counter reset (by reboot). I look at the values of cDot11AssStatsAuthenticated.

Hope this helps.


This Discussion