QoS on Catalyst not runnning,advise pls!

Unanswered Question
Sep 3rd, 2009
User Badges:


I did a ftp test.Speed i got is 25KB/S.it seems like the policy is not taking effect.Any idea?Together is the config.

class-map match-all abc

match access-group 1



policy-map vlan

class abc

police 1000000 65536 exceed-action drop


ip subnet-zero

no ip finger




interface FastEthernet0/1

switchport mode trunk


interface FastEthernet0/2

service-policy input vlan

access-list 1 permit any

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Peter Paluch Thu, 09/03/2009 - 03:18
User Badges:
  • Cisco Employee,


Please go over all the following questions:

What is the type of your switch and the IOS version you are running? Is the "mls qos" command present in the configuration? Is the policy-map applied in the correct direction?

Also note that this policing limits the traffic down to 1 Mbps. You have said that the FTP speed was 25 KBytes/s. That is well under the limit that the policer imposes. Is there something wrong with it?

Best regards,



This Discussion