Calling-Name H323 - Not Showing on Phones

Unanswered Question
Sep 3rd, 2009

Hello All,

I'am having an issue where when using H323 on a 2851 gateway with CUCM 7.1.2, the calling name does not show up on the phones. Now I have done some research on this and I have configured the following. I read that the h225 command "h225 display-ie ccm-compatible "is now integrated into the IOS". Do I need to switch to a code that has the command as a configurable option? I have checked with telco and they are sending us the calling name in the setup messages, I do not see it in the H225 q931 debugs. Any help would be much appreciated thanks!!

voice service voip

signaling forward unconditional

h323

interface Serial0/0/0:23

no ip address

encapsulation hdlc

isdn switch-type primary-ni

isdn incoming-voice voice

isdn supp-service name calling

flash:c2800nm-advipservicesk9-mz.124-25a.bin"

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
steigja Thu, 09/03/2009 - 07:36

Everyone, I rolled back to IOS 124-11.XW10.bin and inputed the following commands and now calling-name works.

voice service voip

h225 timeout ntf 300

h225 display-ie ccm-compatible

Has anyone gotten H323 calling-name to work with a new IOS where these commands are apparently integrated into the IOS?

Actions

This Discussion