09-03-2009 06:21 AM - edited 03-15-2019 07:37 PM
Hello All,
I'am having an issue where when using H323 on a 2851 gateway with CUCM 7.1.2, the calling name does not show up on the phones. Now I have done some research on this and I have configured the following. I read that the h225 command "h225 display-ie ccm-compatible "is now integrated into the IOS". Do I need to switch to a code that has the command as a configurable option? I have checked with telco and they are sending us the calling name in the setup messages, I do not see it in the H225 q931 debugs. Any help would be much appreciated thanks!!
voice service voip
signaling forward unconditional
h323
interface Serial0/0/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
isdn supp-service name calling
flash:c2800nm-advipservicesk9-mz.124-25a.bin"
09-03-2009 07:36 AM
Everyone, I rolled back to IOS 124-11.XW10.bin and inputed the following commands and now calling-name works.
voice service voip
h225 timeout ntf 300
h225 display-ie ccm-compatible
Has anyone gotten H323 calling-name to work with a new IOS where these commands are apparently integrated into the IOS?
09-09-2009 11:21 PM
Hi,
were you able to display the called name?
thanks for your feedback,
08-17-2010 12:06 PM
This command helped me get it working on 15.0(1)M2
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide