09-03-2009 06:21 AM - edited 03-15-2019 07:37 PM
Hello All,
I'am having an issue where when using H323 on a 2851 gateway with CUCM 7.1.2, the calling name does not show up on the phones. Now I have done some research on this and I have configured the following. I read that the h225 command "h225 display-ie ccm-compatible "is now integrated into the IOS". Do I need to switch to a code that has the command as a configurable option? I have checked with telco and they are sending us the calling name in the setup messages, I do not see it in the H225 q931 debugs. Any help would be much appreciated thanks!!
voice service voip
signaling forward unconditional
h323
interface Serial0/0/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
isdn supp-service name calling
flash:c2800nm-advipservicesk9-mz.124-25a.bin"
09-03-2009 07:36 AM
Everyone, I rolled back to IOS 124-11.XW10.bin and inputed the following commands and now calling-name works.
voice service voip
h225 timeout ntf 300
h225 display-ie ccm-compatible
Has anyone gotten H323 calling-name to work with a new IOS where these commands are apparently integrated into the IOS?
09-09-2009 11:21 PM
Hi,
were you able to display the called name?
thanks for your feedback,
08-17-2010 12:06 PM
This command helped me get it working on 15.0(1)M2
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: