09-03-2009 08:39 AM - edited 03-15-2019 07:37 PM
Hi Experts
I have a 2800 Software (C2800NM-ADVIPSERVICESK9-M) on location A, and 2801 Software (C2801-ADVIPSERVICESK9-M) location B. Voip is going trough wan to site b, I am trying to configure xconference but its not working (conferece cannot be completed).
Here is the config:
dial-peer voice 100 voip
destination-pattern 4...
session target ipv4:20x.106.2x6.178
session transport tcp
voice class codec 1
dtmf-relay rtp-nte
no vad
voice class codec 1
codec preference 1 g729r8
sccp ccm group 1
associate profile 1 register Transcode1
associate profile 2 register conference1
dspfarm profile 2 conference
codec g729r8
maximum sessions 2
associate application SCCP
no sh
sccp local FastEthernet0/0
sccp ccm 192.168.0.200 priority 1
sccp
On location B I have:
dial-peer voice 100 voip
destination-pattern 6...
no session protocol sipv2
voice-class codec 1
session target ipv4:20x.19x.135.146
session transport tcp
dtmf-relay rtp-nte
no vad
voice class codec 1
codec preference 1 g729r8
codec preference 2 g711ulaw
codec preference 3 g711alaw
I feel lost a this point, I really will aprecciate any help.
Thanks
09-04-2009 11:36 AM
Hi friend, ccm or cme?
If CCM, the hardware conferences resources are registered in your CCM?
Did you assign the conferences resource to a MRG and this to a MRGL and assign it to the IP Phones?
All the best
David.
09-07-2009 07:07 AM
Thanks for the answer David.
It is CME. I am following this document:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeconf.html#wp1010877
Thanks
09-07-2009 07:40 AM
Hi friend, does the conferencing profile are registered and up? (CME#show dspfarm all), and make sure that your ip phones are configured as dual-lines.
All the best
David.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide