09-03-2009 04:12 PM - edited 03-15-2019 07:38 PM
Hi. I am having an issue on a PRI so that with a dialpeer when i send 011 followed by the number it is being flaged as isdn type international and telco is dumping the call. if i dont prefix the 011 is is flagged as unknown which is also being dumped
I need to flag the call ISDN type as unknown when i prefix with 011. I cant figure out how to do this
dial-peer voice 3 pots
numbering-type unknown
destination-pattern 9011T
port 0/0/0:23
prefix 011
debug output
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98397
Exclusive, Channel 23
Calling Party Number i = 0x2181, '3123245277'
Plan:ISDN, Type:National
Called Party Number i = 0x91, '011441865314280'
Plan:ISDN, Type:International
*Sep 4 00:06:57.287: ISDN Se0/0/0:23 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x810C
09-04-2009 07:34 AM
Heres how I do it.
!
!
voice translation-rule 2
rule 2 /\(011*\)/ /\1/ type any unknown
!
voice translation-profile intunk
translate called 2
!
dial-peer voice 3 pots
translation-profile outgoing intunk
destination-pattern 9011T
port 0/0/0:23
prefix 011
09-04-2009 09:13 AM
Hello,
I had this same issue with a customer yesterday. Under the D-channel interface enter the following:
interface Serialx/x/x:23
isdn map address ^011 plan unknown type unknown
Hope that helped, if so please rate.
02-26-2011 04:47 AM
nice one Kenneth - 5 points from me
09-04-2015 03:37 AM
I have a question about this.
Disregard....I figured it out. removed my question
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide