09-03-2009 04:12 PM - edited 03-15-2019 07:38 PM
Hi. I am having an issue on a PRI so that with a dialpeer when i send 011 followed by the number it is being flaged as isdn type international and telco is dumping the call. if i dont prefix the 011 is is flagged as unknown which is also being dumped
I need to flag the call ISDN type as unknown when i prefix with 011. I cant figure out how to do this
dial-peer voice 3 pots
numbering-type unknown
destination-pattern 9011T
port 0/0/0:23
prefix 011
debug output
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98397
Exclusive, Channel 23
Calling Party Number i = 0x2181, '3123245277'
Plan:ISDN, Type:National
Called Party Number i = 0x91, '011441865314280'
Plan:ISDN, Type:International
*Sep 4 00:06:57.287: ISDN Se0/0/0:23 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x810C
09-04-2009 07:34 AM
Heres how I do it.
!
!
voice translation-rule 2
rule 2 /\(011*\)/ /\1/ type any unknown
!
voice translation-profile intunk
translate called 2
!
dial-peer voice 3 pots
translation-profile outgoing intunk
destination-pattern 9011T
port 0/0/0:23
prefix 011
09-04-2009 09:13 AM
Hello,
I had this same issue with a customer yesterday. Under the D-channel interface enter the following:
interface Serialx/x/x:23
isdn map address ^011 plan unknown type unknown
Hope that helped, if so please rate.
02-26-2011 04:47 AM
nice one Kenneth - 5 points from me
09-04-2015 03:37 AM
I have a question about this.
Disregard....I figured it out. removed my question
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: