RME collection Status problem

Unanswered Question
Sep 4th, 2009
User Badges:

In RME collection status under config archive in partially successfull tab i am getting this error message " Command failed VLAN Config fetch is not supported using TFTP. Could not detect SSH protocols running on the device VLAN Config fetch is not supported using RCP. " please explain this eror message.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Fri, 09/04/2009 - 08:23
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

The VLAN config can only be fetched using SSH or telnet. RME will connect tot he device, then issue a "copy flash:vlan.dat tftp:". This error says that RME could not detect that SSH was running on the device, and telnet did not appear to be in the protocol order.

Joe Clarke Mon, 09/07/2009 - 10:19
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Make sure you can establish an enabled SSH or telnet session from the CiscoWorks server using the same credentials that are configured in DCR.

akash03lingam Wed, 09/09/2009 - 06:10
User Badges:

Could you please tell me how can i delete the old status under partially sucessful tab in RME

Joe Clarke Wed, 09/09/2009 - 10:10
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Assuming you've worked out the connection issues, go to RME > Config Mgmt > Archive Mgmt > Sync Archive, and check the Fetch Startup box. If the Sync Archive job runs successfully (and all configs are fetched), then the device will move to a Successful state.

Actions

This Discussion