After WAAS deployment network is dead slow

Unanswered Question
Sep 6th, 2009

Hi All

After deploying WAAS , i.e. WAE-302 module in Cisco 2811 Router on core and edge with default setting and running wccp on the router , network is dead slow .

Core and edge network are connected with dedicated 2MB lease line.

License is Transport.

I can see traffic optimizing on WAE core and Edge but netwrok is dead slow.

Any suggestions.

Regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mrjohnso Tue, 09/08/2009 - 09:25

What was changed on the routers during this implementation? Only configuring the module, enabling wccp 61/62 and enabling redirection on the LAN/WAN interfaces?

Were additional routes added? Is it possible a routing loop was introduced? Do you see a reasonable number of connections on the WAEs?

I suggest looking at the following to see if any problems are indicated:

On the routers:

show ip wccp - should see most packets redirected via CEF

On the WAEs:

show wccp gre - look for any high counters that don't look right

type-tail syslog.txt 50 - look for messages indicating possible problems

Actions

This Discussion