Second call in the mode of peer to peer

Unanswered Question
Alberto Montilla Tue, 09/08/2009 - 09:59
User Badges:
  • Cisco Employee,

Dear Sir;


This has to do with the ports used for SIP for each line.


Line 1 is 5060

Line 2 is 5061


On the peer device you need to set the proxy to be : (port is included only if different from 5060).


It seems that other end is trying to call to the 5060 port, and local device is saying "Not Found". Try setting :5061 for the second line (on the peer device).


Regards
Alberto

Hello, Alberto 
Thank you very much for addressing this issue, but I will say that this decision is grossly hardware, if we take for example cisco 827 there is no need to specify which port the call comes, it automatically determines which port will be used.
And if we assume that one room for 2 lines, can we not creating a second dialpeer on cisco, as some do. Just like any other device that works.

dial-peer voice 3808102 voip 
  destination-pattern 3808102 
  session protocol sipv2 
  session target ipv4: 91.190.82.10 
  codec g726r32 bytes 40 
  fax-relay ecm disable 
  fax nsf 000000 
  fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none 
  no vad



Regards
Max

Actions

This Discussion