Can any one please tell me how to convert Access point 1242 from standalone / infrastructure mode to LWAP mode.
I am not able to intergrate these with my Controller 2100 .
Ap1242 details below:-
DH_3750_SWITCH_STACK#sh cdp nei fa 3/0/21 detail
Device ID: ap
IP address: 10.120.249.3
Platform: cisco AIR-AP1242AG-E-K9 , Capabilities: Trans-Bridge IGMP
Interface: FastEthernet3/0/21, Port ID (outgoing port): FastEthernet0
Holdtime : 129 sec
Cisco IOS Software, C1240 Software (C1240-K9W7-M), Version 12.3(8)JEA2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Tue 17-Jul-07 23:02 by ccai
You have two options.
One, convert to Autonomous and re-convert back to LWAPP.
Two, the command is "disabled" because you are already running the LWAPP image. Your LWAP contains two IOS images: One has the prefix of "rcv" and the other is the image downloaded from the WLC. Delete this image, let the AP boot the "rcv" image and run the command again.