Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
326
Views
0
Helpful
2
Replies

Enable only 802.11b for a single WLAN?

severi
Level 1
Level 1

‎09-08-2009 06:12 AM - edited ‎07-03-2021 06:01 PM

I have only 802.11b client in my production environment (PLC, serial converter, ecc..).

On my WLC how can I configure a single WLAN 802.11b only and other WLAN with all-mode enable?

Regards.

Mirko S.

Labels:
0 Helpful
2 Replies 2

dancampb
Level 7
Level 7

‎09-08-2009 08:15 AM

When you edit the WLAN, on the General page there is a dropdown for the Radio policy. Just select which bands you want to support on the WLAN.

0 Helpful

severi
Level 1
Level 1
In response to dancampb

‎09-08-2009 12:33 PM

Sorry, there is a band 802.11g, 802.11b/g but not 802 .11b.

Is correct?

In this time I had to set the datarate 1, 2, 5.5 and 11M.

I do not think it's the right solution.

Regards.

Mirko S.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card