WMI Scripts not Running Across VPN

Unanswered Question
Sep 8th, 2009

Hi

I have a strange problem where i have 2 sites connected  using  a VPN on 2  CISCO877.  But WMI scripts are not running across the link. if i pull these out an replace them with a Draytek, the scripts run fine.

Broad Lane LAN ----- Cisco 877 ========= Internet & VPN Tunnel ============== Cisco 877 ---- Southam LAN1.0.39.0/8                      1.0.39.253                                                                                                              192.168.55.1   192.168.55.0/24 The server at Broad Lane is  GIMILI (1.0.39.109) and at Southam is FRODO (192.168.55.4). The following will not work through the tunnel from Broad Lane LAN. Set objWMIService = GetObject("winmgmts:\\192.168.55.4\root\cimv2") if err.number=0 then serverexist=true else serverexist=falsemsgbox(server.exist)

Is is possible for the  CISCO877 to block WMI traffic?

Any suggestions please?

Rgds

Phil

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
William Childs Tue, 09/08/2009 - 23:57

Phil,

Thank you for your question.  This community is for Cisco Small Business products and your question is in reference to a Cisco Elite/Classic product.  Please post your question in the Cisco NetPro forums located here: http://forums.cisco.com/eforum/servlet/NetProf?page=main  This forum has subject matter experts on Cisco Elite/Classic products that may be able to answer your question.

Bill

Actions

This Discussion