SUP Sync

Unanswered Question
Sep 8th, 2009

Hi,

I have the switch running with single SUP And the 2nd SUP is faulty. I got a new SUP from CISCO. However, the new SUP is having different ISO as compare to the existing SUP. Now I want sync the configuration & configure SUP as backup to other. Please advice me how to go forward.

Thanks!!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jbrenesj Tue, 09/08/2009 - 13:40

What is the platform, 6500 or 4500?

what is the file system of the active sup, bootflash:, disk0: or bootdisk:

You can do a dir slavebootflash: for example to confirm you have access to the standby sup and then you can copy the IOS from the active to the standby, do a write mem and reload the standby sup to it loads the same IOS as the active + the config file

arun.patro Tue, 09/08/2009 - 14:00

Hi,

It's 6500 & having CATOS.

I tried to access slavebootflash:, but no luck

Switch> (enable) dir slavebootflash:

Open device slavebootflash failed (unknown device)

Switch> (enable)

Also, fyi pls

Mod Hw Fw Sw

--- -------------------------------------- ------ ---------- -----------------

1 3.2 5.3(1) 5.4(4)

15 1.1 12.1(8b)E7 12.1(8b)E7

2 7.0 5.3(1) 6.4(9)

16 1.1 12.1(8b)E1 12.1(8b)E15

SUP in slot is the one I got from Cisco in RMA. They are having different Hw, Fw, Sw versions.

Pls advice. Thanks!!

Actions

This Discussion