09-08-2009 01:33 PM - edited 03-06-2019 07:38 AM
Hi,
I have the switch running with single SUP And the 2nd SUP is faulty. I got a new SUP from CISCO. However, the new SUP is having different ISO as compare to the existing SUP. Now I want sync the configuration & configure SUP as backup to other. Please advice me how to go forward.
Thanks!!
09-08-2009 01:40 PM
What is the platform, 6500 or 4500?
what is the file system of the active sup, bootflash:, disk0: or bootdisk:
You can do a dir slavebootflash: for example to confirm you have access to the standby sup and then you can copy the IOS from the active to the standby, do a write mem and reload the standby sup to it loads the same IOS as the active + the config file
09-08-2009 02:00 PM
Hi,
It's 6500 & having CATOS.
I tried to access slavebootflash:, but no luck
Switch> (enable) dir slavebootflash:
Open device slavebootflash failed (unknown device)
Switch> (enable)
Also, fyi pls
Mod Hw Fw Sw
--- -------------------------------------- ------ ---------- -----------------
1 3.2 5.3(1) 5.4(4)
15 1.1 12.1(8b)E7 12.1(8b)E7
2 7.0 5.3(1) 6.4(9)
16 1.1 12.1(8b)E1 12.1(8b)E15
SUP in slot is the one I got from Cisco in RMA. They are having different Hw, Fw, Sw versions.
Pls advice. Thanks!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: