cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
502
Views
0
Helpful
4
Replies

Inbound Fax load balancing

jawwalit
Level 1
Level 1

Hello,

i have the following scenario:

1- one gateway (PRI Line interface)

2- two RightFax servers

i used a SIP protocol between the gateway and the two fax servers , my point is how to configure a dial-peers on a gateway to make an inbound balancing fax call between the two fax server, the following is the configuration for the gateway:

### connection to the Fax Server #####

dial-peer voice 200 voip

destination-pattern 9979..

voice-class codec 99

session protocol sipv2

session target ipv4:10.72.28.110

session transport udp

dtmf-relay h245-signal

fax rate 14400

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none

!

#### Connection to the server Fax2 ####

dial-peer voice 201 voip

destination-pattern 9979..

voice-class codec 99

session protocol sipv2

session target ipv4:10.72.28.111

session transport udp

dtmf-relay h245-signal

fax rate 14400

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none

#########################

what additional command needed to achieve load balancing?

4 Replies 4

That's all you need.

You can use "show dialplan number " to see what dial peers will be used.

-nick

thanks , yes its work

but i has some problem, that when i shutdown one of the fax server the gateway still send fax to it even its down,

do you have any explain for that

Thanks

It will try, and when it is unreachable, it will attempt to send to it.

You may want to look into Out of Dialog (OOD) options pings. This will allow you to monitor the health of a SIP endpoint and fall-back when something fails.

thanks,

nick

Can you try "no huntstop" under DP ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: