C6509-E and VS-S720-10G visio stencils

Unanswered Question
Sep 10th, 2009
User Badges:

Hi there,

I need those two stencils.

I have checked here http://www.cisco.com/en/US/prod/assets/visio/product_visio_icon0900aecd800fd93c.zip but:

- the one for the C6509-E is not there

- the one for the supervisor does not work properly (misaligned anchor points).

Thanks for helping...

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
andrecsthompson Tue, 04/30/2013 - 13:35
User Badges:

Also I am looking for the following stencils:

CEF720 16 port 10GE                    WS-X6816-10GE

CEF720 48 port 10/100/1000mb Ethernet  WS-X6848-GE-TX

The stencils above are very old

Islam Sallaj Tue, 06/02/2015 - 13:57
User Badges:

Did you ever find stencil:



It's no where to be found

Greg Grimes Wed, 08/07/2013 - 09:03
User Badges:

Yes, the glue points for the VS-Sup720-10G are wrong and I can't figure out how to change them.  However, the VS-Sup720-10G-3C(&XL) has the glue points in the correct location.

Greg Grimes Wed, 08/07/2013 - 09:10
User Badges:

Hmm.  I've tried doing that by following the guides online. 


That guide says that I shoud be able to add my own, but it won't take them.  Matter of fact, the glue points APPEAR to be in the right location, but they still show up wrong after you go back to the pointer tool.

andrecsthompson Wed, 08/07/2013 - 09:39
User Badges:

Hi Greg

Here are some tips:

1. Before selecting the Connector Tool, ensure the SUP-720 object is selected or you will be adding the points to nothing.

2. Try zooming in before adding the points, such as 400% or more.I go in as much as 800%

3. I would recommend using Visio 2013 or Visio 2010 but not earlier.

Hope this was helpful. I would like to hear your feedback on this.


This Discussion