Cisco 2811 Dial up Internet Configuration Problem

Answered Question
Sep 10th, 2009
User Badges:

I have the following dial up problem please help me overcome this problem


i have configured Cisco 2811 to be used as a dial up router with one E1, so that subscriber can dial in and use the internet.


the problem is that when adding "interface Group-Async1" the command (group-range 1 30) when i excute this command it indicates accepting the command but when i show config, i am still getting (group-range 1 1.


below is the show ver result.


STEL#sh ver

Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(21a), RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2008 by Cisco Systems, Inc.

Compiled Mon 29-Sep-08 16:02 by prod_rel_team


ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)


STEL.Hargeisa uptime is 3 minutes

System returned to ROM by power-on

System image file is "flash:c2800nm-advipservicesk9-mz.124-21a.bin"



This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.


A summary of U.S. laws governing Cisco cryptographic products may be found at:

http://www.cisco.com/wwl/export/crypto/tool/stqrg.html


If you require further assistance please contact us by sending email to

[email protected].


Cisco 2811 (revision 53.50) with 247808K/14336K bytes of memory.

Processor board ID FHK1204F3UT

2 FastEthernet interfaces

31 Serial interfaces

1 Channelized E1/PRI port

1 Virtual Private Network (VPN) Module

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

63808K bytes of ATA CompactFlash (Read/Write)


Configuration register is 0x2102


Hassan R.


Correct Answer by paolo bevilacqua about 7 years 10 months ago

Both of them.


Please remember to rate useful posts with the scrollbox below.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
paolo bevilacqua Sat, 09/12/2009 - 02:01
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You're welcome, please remember to rate useful posts with the scrollbox below.

hirmoge123_2 Sun, 09/13/2009 - 20:37
User Badges:

Do I need both cards or one of them:

PVDM2-36DM and HWIC-1CE1T1-PR

Correct Answer
paolo bevilacqua Mon, 09/14/2009 - 03:46
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Both of them.


Please remember to rate useful posts with the scrollbox below.

Actions

This Discussion