Lost control of Integrated-Service-Engine (WLCM)

Unanswered Question
Sep 10th, 2009
User Badges:

How do I regain communication with WLCM in a 2821?


I was trying to get this running and had gone through the wizard for the basic config and could session to the controller before discovering the IP addressing I used was in the wrong MPLS VRF. I did a clear config and reset system, save: no.


Even putting the IP I originally used back on int in1/0 I cannot session to the controller module.



router-mpls#service-module Integrated-Service-Engine 1/0 session

Trying **.*.*.***, 2066 ...

% Connection refused by remote host


I have not reloaded the 2821 except that is did crash & reload on its own during this. A scheduled reload will take a figurative act of congress to approve.


ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)


router-mpls uptime is 1 day, 18 hours, 18 minutes

System returned to ROM by error - an Illegal Opcode exception, PC 0x8CA1E1AC at 15:13:30 MDT Tue Sep 8 2009

System restarted at 15:15:50 MDT Tue Sep 8 2009

System image file is "flash:/c2800nm-advipservicesk9-mz.124-22.T.bin"


Any suggestions?


Router:

Cisco 2821 (revision 53.51) with 1028096K/20480K bytes of memory.

Processor board ID ***********

2 Gigabit Ethernet interfaces

1 terminal line

1 Virtual Private Network (VPN) Module

1 cisco Integrated Service Engine(s)

Cisco WLAN Controller 4.2.61.0 in slot 1

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

250880K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
khushal05 Sun, 06/13/2010 - 09:42
User Badges:

Experiencing the same issues on UC500 after Power Outtage -

Have done reset, Powerdown - and also will not allow software upgrade either.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode