NAM VB

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
hadbou Thu, 09/17/2009 - 07:49

To generate WAAS before-and-after reports by collecting response time information from the client data source and combining it with information from the Passthru data source.

Step 1 Log in to the WAE.

Step 2 Configure the WAE to optimize the server traffic with the following commands:

config t

tfo optimize full

The purpose of this is to have the NAM VB receive optimized flows to enable post-WAAS impact analysis.

Step 3 Wait for 15-30 minutes (or longer depending on the application) for the Client report to collect data.

Step 4 On the NAM GUI, click Monitor > Response Time for the Client data source and collect the baseline server response time numbers. You can get more metrics by choosing the server and clicking Details.

http://www.cisco.com/en/US/docs/net_mgmt/network_analysis_module_virtual_blade/4.1/install/guide/beforeafter.html

Actions

This Discussion