I have a 2821 router running IOS:
System image file is "flash:/c2800nm-adventerprisek9_ivs-mz.124-3g.bin"
The issue is that the terminal length is always 0 and if manually set it for example to 24, it is only good for that session and the show terminal command show the length 24, but as soon as I log out and log back in, it goes back to 0 and of course the show terminal command shows also 0
I believe the default should be 24, but this router is 0
Has any one experienced this before?
Also, here is the show terminal out put:
T-1# ter length 24
Line 322, Location: "", Type: "VT100"
Length: 24 lines, Width: 0 columns
Baud rate (TX/RX) is 9600/9600
Status: PSI Enabled, Ready, Active, No Exit Banner, Automore On
Modem state: Ready
Group codes: 0
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
01:00:00 never none not set
Idle Session Disconnect Warning
Login-sequence User Response
Autoselect Initial Wait
Modem type is unknown.
Session limit is not set.
Time since activation: 00:26:08
Editing is enabled.
History is enabled, history size is 20.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are telnet ssh.
Allowed output transports are lat pad telnet rlogin lapb-ta mop v120 ssh.
Preferred transport is lat.
No output characters are padded
No special data dispatching characters