Can someone point me in the right direction.
I have an ASA 5505 setup with both remote access (Anyconnect), as well as a site to site tunnel over to a business partner.
From the outside, I can connect via anyconnect and go anywhere within my internal network. From the inside (when at the office where ASA is at) I can route to any destination on partner side (over site to site tunnel). But what I can't do, is when I connect via remote access from outside, is access the partner side network over the site to site tunnel. Can't ping any address on other side.
u used the vpn wizards to create both remote access and site to site tunnels.
thanks in advance,
Daniel, sorry for not giving you an example in my previous post which sounds confusing :)
I was able to fine a thread from while back , follow the example , apply the same principle for your anyconnect . should work. if you need help let me know to help you out.