cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
414
Views
0
Helpful
2
Replies

Determine if Supervisor is V or IV with RME

sirbaughmf
Level 1
Level 1

I'm trying to run a report in RME that will show me what supervisor type my 4500 and 6500 devices are running. I've looked in Detailed Device Report and don't see it either. Any suggestions?

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

There may not be a clear indication of Sup type in the RME reports. RME reports on the SNMP object name of either the module type of the entPhysicalVendorType.

The Cat4K sup IV is cevCat4kWsx4515, and the Sup V is cevCat4kWsx4516.

View solution in original post

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

There may not be a clear indication of Sup type in the RME reports. RME reports on the SNMP object name of either the module type of the entPhysicalVendorType.

The Cat4K sup IV is cevCat4kWsx4515, and the Sup V is cevCat4kWsx4516.

Good enough, I can work with that...thanks!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco