cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1530
Views
0
Helpful
1
Replies

7961G addon 7915 in CME 7

mohamedessoufy
Level 1
Level 1

Hi,

is the extention module 7915 compatible supported with 7961G in CM Express please, because it doesn't work for me ?

Regards

1 Accepted Solution

Accepted Solutions

jcaro
Cisco Employee
Cisco Employee

No the 7961G only works with the 7914.

See below compatibilities

Cisco Unified IP Phone 7914 Expansion Module

The Cisco Unified IP Phone 7914 Expansion Module supports the following Cisco Unified IP Phones that run SCCP and SIP: 7960G, 7961G, 7961G-GE, 7962-GE, 7965-GE, 7970G-GE, and 7971G-GE, and 7975G-GE.

Cisco Unified IP Phone 7915 Expansion Module

The Cisco Unified IP Phone 7915 Expansion Module supports the following Cisco Unified IP Phones that run SCCP and SIP: 7962G, 7965G, and 7975G. Phones that run SCCP must run Cisco Firmware Release 8.3(5) or a later release. Phones that run SIP must run Cisco Firmware Release 8.4(1) or a later release.

Cisco Unified IP Phone 7916 Expansion Module

The Cisco Unified IP Phone 7916 Expansion Module supports the following Cisco Unified IP Phones that run SCCP and SIP: 7962G, 7965G, and 7975G. Phones that run SCCP must run Cisco Firmware Release 8.3(5) or a later release. Phones that run SIP must run Cisco Firmware Release 8.4(1) or a later release.

View solution in original post

1 Reply 1

jcaro
Cisco Employee
Cisco Employee

No the 7961G only works with the 7914.

See below compatibilities

Cisco Unified IP Phone 7914 Expansion Module

The Cisco Unified IP Phone 7914 Expansion Module supports the following Cisco Unified IP Phones that run SCCP and SIP: 7960G, 7961G, 7961G-GE, 7962-GE, 7965-GE, 7970G-GE, and 7971G-GE, and 7975G-GE.

Cisco Unified IP Phone 7915 Expansion Module

The Cisco Unified IP Phone 7915 Expansion Module supports the following Cisco Unified IP Phones that run SCCP and SIP: 7962G, 7965G, and 7975G. Phones that run SCCP must run Cisco Firmware Release 8.3(5) or a later release. Phones that run SIP must run Cisco Firmware Release 8.4(1) or a later release.

Cisco Unified IP Phone 7916 Expansion Module

The Cisco Unified IP Phone 7916 Expansion Module supports the following Cisco Unified IP Phones that run SCCP and SIP: 7962G, 7965G, and 7975G. Phones that run SCCP must run Cisco Firmware Release 8.3(5) or a later release. Phones that run SIP must run Cisco Firmware Release 8.4(1) or a later release.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: