09-16-2009 12:01 AM
Hi,
I have three questions regarding the "show stats connection" command in the ACE 4710:
1. What is the criteria for a connection to be added to the "Total Connections Failed" counter?
2. What is the criteria for a connection to be added to the "Total Connections Timed-out" counter?
3. Is there a command to get more information why the connection was failed or timed-out (e.g. to/from which IP, url accessed etc.)?
Thanks in advance for your help!
Best regards,
Harry
Solved! Go to Solution.
09-16-2009 12:33 AM
Harry,
a connection failed if the server did not respond or resonded with a RST.
As long as the connection gets establised, it is counted as a success.
The connection timeout counter is incremented when the connection is idle for the configured timeout value or for L7 connections if it does not complete the 3-way handshale within the embryonic timeout interval.
Since this is clear why those counters are incrementing, the only way to get more information is to capture a sniffer trace to verify if the conditions above are met.
Gilles.
09-23-2009 03:53 AM
09-16-2009 12:33 AM
Harry,
a connection failed if the server did not respond or resonded with a RST.
As long as the connection gets establised, it is counted as a success.
The connection timeout counter is incremented when the connection is idle for the configured timeout value or for L7 connections if it does not complete the 3-way handshale within the embryonic timeout interval.
Since this is clear why those counters are incrementing, the only way to get more information is to capture a sniffer trace to verify if the conditions above are met.
Gilles.
09-16-2009 01:15 AM
Hi Gilles,
Thanks for your quick answer!
Is it only failed and timed-out connections to the serverfarms that are counted, or also SSL connections to the ACE itself?
If only connections to the serverfarm are counted, should I then be able to see the same number of failed connections if I add up the number of connections failures from the output of "show serverfarm detail" (if the counters have been cleared at the same time)?
Best regards,
Harry
09-16-2009 01:48 AM
Failed connection is every connection that could not be established.
So even routed connections could fail if you do not have a route to the destination or the destination mac-address.
Gilles.
09-22-2009 12:00 AM
Hi again,
Would even e.g. HSRP traffic or broadcasts that the ACE receives from routers on the same subnet be counted as failed connections?
We seem to be getting a lot of failed connections even though we do not see any issues with the service.
Best regards,
Harry
09-23-2009 03:53 AM
yes, HSRP, VRRP will be counter as failed connections.
Gilles.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide