Help with igmp static-group

Answered Question
Sep 16th, 2009

Hi

I've got a source registered:

sh ip pim rp:

Group: 239.48.181.10, RP: 10.239.45.1, next RP-reachable in 00:01:04

sh ip igmp groups:

239.48.181.10 Vlan180 02:28:11 00:02:12 10.45.180.38

However,

On the same swithch if I do the following on a vlan:

interface Vlan62

ip address 10.45.62.254 255.255.255.0

ip igmp static-group 239.48.181.10

ip pim sparse-mode

standby 62 ip 10.45.62.1

standby 62 priority 110

standby 62 preempt delay minimum 60

end

after adding an igmp static-group I then run:

sh ip igmp groups vlan 62

IGMP Connected Group Membership

Group Address Interface Uptime Expires Last Reporter

228.1.2.3 Vlan62 00:00:05 00:02:54 10.45.62.100

239.48.181.10 Vlan62 00:00:07 stopped 0.0.0.0

My question is why is 239.48.181.10 showing up as stopped?

Thanks

Dan

I have this problem too.
0 votes
Correct Answer by rducombl about 7 years 2 months ago

Hi Dan,

Because static-group will be there forever. So it won't timeout and as we do not run the timers on the igmp entry , we mark it as stopped.

This is expected behaviour for igmp static-group

Roland

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
rducombl Wed, 09/16/2009 - 03:19

Hi Dan,

Because static-group will be there forever. So it won't timeout and as we do not run the timers on the igmp entry , we mark it as stopped.

This is expected behaviour for igmp static-group

Roland

Actions

This Discussion