Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
356
Views
0
Helpful
3
Replies

Call Manager Enet Interfaces

Go to solution
mcecilia
Level 1
Level 1

‎09-16-2009 02:46 AM - edited ‎03-15-2019 07:46 PM

Hello All,

Call Manager on MC7845 have two ethernet interfaces.

How does both work? Active/Standby , Load Balanced / Etherchannel.

Can one have 1gb speed and the other 100Mpbs.

Many thaks

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
paolo bevilacqua
Hall of Fame
Hall of Fame
In response to mcecilia

‎09-16-2009 03:04 AM

Should not be changed, it is the best way for redundancy so you can connect to two switches.

View solution in original post

0 Helpful
3 Replies 3

Go to solution
paolo bevilacqua
Hall of Fame
Hall of Fame

‎09-16-2009 02:59 AM

Which CM version ?

0 Helpful

Go to solution
mcecilia
Level 1
Level 1
In response to paolo bevilacqua

‎09-16-2009 03:02 AM

Sorry. Using CM 6 and planning CM 7.

I have found the command "set network failover enable" that makes a team between enets interfaces in a active/standby configuration, migrating the licensed mac from one interface to the other in a failover. But, do not know if this behaviour or configuration can be changed.

Thanks

0 Helpful

Go to solution
paolo bevilacqua
Hall of Fame
Hall of Fame
In response to mcecilia

‎09-16-2009 03:04 AM

Should not be changed, it is the best way for redundancy so you can connect to two switches.

0 Helpful
Customers Also Viewed These Support Documents