1841 router and multiple public IPs on WAN interface

Unanswered Question
Sep 16th, 2009
User Badges:

Looking for confirmation I can do this. 1841 has 2 interfaces: FE 0/0 and FE 0/1. 0/0 is WAN w/public IP of LAN is FE 0/1 with Currently have users using browser-based access to IP cameras by, where xxxx is replaced by the port number mapped to each individual IP camera. Sounds like the hard way to do it, but there ARE reasons for doing it this way.

Command is:

Router1(config)#ip access-list extended BasicNAT

Router1(config-ext-nacl)#3 deny ip host any

Router1(config-ext-nacl)#4 deny ip host any


Router1(config)#ip nat inside source static tcp 9101 9101

Router1(config)#ip nat inside source static tcp 9102 9104

Select Users want to be able to control the Air Conditioner via their web browser, as well. The program used to control uses TCP ports 3011, 1911 and 80. I do not want to map port 80 on this WAN ip to the air conditioner.

Can I use another one of the public IPs assigned by the T1 ISP provider? For example, NAT to the LAN IP? Then, users will go and ports 80, 3011, and 1911 will work? Or, do I need a 3rd FE interface to make this happen?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Wed, 09/16/2009 - 11:06
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Yes, you can use all the IP and ports you want for static NAT (PAT).


This Discussion