cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
485
Views
0
Helpful
2
Replies

PBR on Cisco 3560

davidhuynh5
Level 1
Level 1

I want to route all traffic from 10.20.1.0/24 (Vlan1) to the next hop address 10.0.0.1 (see diagram).

When I try to put the cmd "ip policy route-map pbr_fa0/1" on Vlan1, the cmd is accepted, but does not show up in the configuration. Why? When I test my PBR, it does not work. Thanks in advance.

2 Replies 2

davidhuynh5
Level 1
Level 1

sorry guys I figured out the problem.

I have to enable "sdm perfer routing". Once I did that it worked.

David

Congratulations on figuring out the solution to your own problem. And thanks for posting back to the forum indicating that you have solved it yourself. It makes the forum more useful when people can read about a problem and can read what was the solution to the problem. You have contributed to that.

HTH

Rick

HTH

Rick
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: