Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
5608
Views
0
Helpful
4
Replies

SCCP 7911s showing Unprovisioned on LCD display

Jason Aarons
Level 6
Level 6

‎09-16-2009 10:08 PM - edited ‎03-15-2019 07:47 PM

Running CallManager 7.1(2) I had our staging group put SCCP loads on 7911s.

Onsite I plug the phones in and see Unprovisioned. Like they are trying to use SIP!?!

We are all SCCP, the phones are in CallManager correctly as SCCP.

Any ideas? If they do have SIP loads on them how do I convert them back to SCCP?

1 person had this problem
Labels:
0 Helpful
4 Replies 4

paolo bevilacqua
Hall of Fame
Hall of Fame

‎09-17-2009 12:55 AM

Check again if they are SIP or SCCP. You can use the reset sequence to convert them easily. Just check you have the correct (SCCP) term06.default.loads and term11.default.loads on the TFTP server.

0 Helpful

Jason Aarons
Level 6
Level 6
In response to paolo bevilacqua

‎09-17-2009 03:27 AM

Does the # at PowerOn, then 123456789*0# have anything to do with changing between SIP and SCCP?

We did a factory reset using that sequence, wondering if that has something to do with the change from SCCP to SIP.

Will be onsite later.

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to Jason Aarons

‎09-17-2009 04:51 AM

Yes, at that point phone looks for termxx.default.loads and the related files.

If by mistake you kept the SIP version of that, it would convert to SIP and get stuck there.

0 Helpful

Anas Hafez
Level 1
Level 1

‎08-06-2023 11:39 PM

Make sure the IP phone's phone load name or device defaults firmware name is available in CUCM TFTP > TFTP File Management

0 Helpful
Customers Also Viewed These Support Documents