09-16-2009 11:20 PM - edited 03-04-2019 06:05 AM
I am trying to make logical Interfaces on my Cisco 2811 Ethernet WAN port,
I will use two internet connections on this port,, both connections will be terminating on a layer 2 switch, D-Link, and the switch will be connected to the Router,
Is it possible?????
The router asks me to first make this port for ISL or 802.1q....
09-17-2009 12:25 AM
Hello,
Yes it is possible to do this.
what i will suggest is that u can create a trunk between router and the the D-link switch. Please revert for any more clarification. Also put the logs in the next post, if u face any more issues
09-17-2009 01:32 AM
can you please give me any example,,,
09-17-2009 01:45 AM
You need a switch with 802.1q VLAN support, it's quite possible the one you have doesn't do that, so get a cisco a linksys switch.
09-17-2009 04:58 AM
ok.. lets assume that I have it... then....
should I configure it the same way we do Inter vlan Routing???
09-17-2009 05:07 AM
Yes.
Please remember to rate useful posts with the scrollbox below.
09-17-2009 07:46 AM
ok,, sure,, let me check it out first..:-)
09-18-2009 03:23 AM
Should I be able to configure Soft IPsec VPN on the router????
and the users will communicate with 2 live IPs,, I mean,, some users will use one , and the others will use the second one,,,
As well, I want to configure the site-to-Site VPN...
The main Objective is to use only one ethernet WAN Port...
09-18-2009 04:18 AM
You can do that.
If you have no experience in configuring routers, VPN etc, I recommend you hire a certified professional for safe results without business-affecting mistakes.
09-18-2009 04:50 AM
:-)
I am CCNA Certified,,
Actually due to short down time, I want to complete the documentation first.. and want to ensure that this will work,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: