09-17-2009 09:14 AM - edited 03-06-2019 07:46 AM
I have been searching around, I know it is part of the 12.2 Firmware and beyond, but not finding any specific information in regards to this.
Solved! Go to Solution.
09-17-2009 09:20 AM
Yes, please refer to the documentation:
09-17-2009 09:19 AM
Hello,
it is supported see the config chapter for 12.2(44)SE
you may need to check the following:
>>To use this feature, the switch must be running the IP services image (formerly known as the enhanced multilayer image [EMI]).
you need also to check the sdm you have
show sdm prefer
Hope to help
Giuseppe
09-17-2009 09:20 AM
Yes, please refer to the documentation:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: