09-17-2009 01:06 PM - edited 03-15-2019 07:48 PM
CCM 4.2 Sets = 7900
Does call manager have an option or setting to control the duration of a call.
We have a joker on site who is queuing up the PA amp via CCM phone then walking away, leaving the hanset off.
From the phone we dial a code <*555> that hits a route pattern that hits a router then a PA interface and then the PA amp.
we would like to make this call a max duration of 30 seconds. any ideas?
Many Thanks
09-17-2009 02:02 PM
Hi!
What about using the following?
This command will make the port to remain connected for 30 seconds after no voice activity is detected by the voice port:
voice-port 1/0/1
timeouts teardown lmr 30
Refer to:
http://www.cisco.com/en/US/docs/ios/voice/command/reference/vr_t2.html#wp1641006
Regards,
Teresa.
If it hopes please rate! :)
09-18-2009 05:21 AM
Thanks Teresa -
I figured if it could be done it would be done at the port level. But what if there is a lot off backround noise, this would count as voice thus activity?
Also this port a FXS on a 2600 router.
Thanks again
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: