09-17-2009 08:23 PM - edited 03-06-2019 07:46 AM
How to set login username and password for telnet and ssh?
09-17-2009 08:37 PM
aaa new-model
aaa authentication login default local enable
username user1 password mypassword
#### Below is the enable password ###
enable password mypassword
##################
The above command will set user logins for both telnet and SSH.
Hope this helps.
09-17-2009 08:58 PM
without enabling
aaa new-model
how to set username and password for telnet and ssh
09-17-2009 09:37 PM
username jdoe privilege 15 password cisco
line vty 0 4
login local
09-18-2009 02:51 AM
hi there
what is the, enable bit for at the end of the following command ?
aaa authentication login default local enable
cheers
09-18-2009 03:02 AM
Means that you can use the enable password to login if for some reason there is no UN or PW configured.
09-23-2019 09:36 AM
Thanks for your help.
09-23-2019 10:43 AM - edited 09-23-2019 12:04 PM
Hello
The below should provide you with local privilege level 15 access for line interfaces
conf t
username AdmiN privilege 15 secret xxxxx
aaa new-model
aaa authentication login default local-case
aaa authorization exec default local if-authenticated
aaa authorization console
Lastly telnet /ssh will be enabled by default on all vty lines but this can be restricted ingress/egress if you wish to.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: