09-18-2009 01:46 AM - edited 03-06-2019 07:46 AM
Hi,
What IOS version do i need for using the Cisco Configuration Professional on a 1861? I want to use a gui for this device
09-18-2009 02:29 AM
You need Secure Device Management or SDM.
09-21-2009 11:19 PM
thanks, but please look at the following site: http://www.cisco.com/en/US/prod/collateral/routers/ps5853/ps8321/prod_qas0900aecd806c4def.html
The SDM is not supported for the 1861
09-21-2009 11:29 PM
David,
You are correct and CCP is supported on the 1861 router. It requires 124-11.XW6 or 12.4(20)T and later IOS versions.
http://www.cisco.com/en/US/prod/collateral/routers/ps9422/data_sheet_c78_462210.html
HTH,
Mark
09-21-2009 11:33 PM
Thanks Mark,
we've tried this with xw6 and 20t but the ccp gives a error message - something like "hardware platform not supported"
09-21-2009 11:35 PM
What version of CCP are you using? This guide references version 1.4.
Mark
09-21-2009 11:56 PM
1.4
09-22-2009 05:36 PM
There an issue on CCP 1.4 for vlan interfaces on 1861. This will be fixed in CCP 2.0, that one is coming out soon.
09-22-2009 11:35 PM
ok, thanks for the answer.
So, what is the workaround? Do i have to use a static ip?
09-23-2009 08:36 AM
Workaround is to use the CLI in the meantime.
2.0 should be released in a few weeks.
10-26-2009 06:18 AM
Hi,
so, after installing configuration professional 2.0 - same problem. "unsupported platform". we have "C1861W-SRST-B/K9" (note - with wlan). when i look at the supported hardware document - every device is supported but not the "C1861W-SRST-b/K9". Could it be, that this platform is totally not supported?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: