AIM-CUE on CCME

Unanswered Question
Sep 18th, 2009
User Badges:

Hi,


we have a customer with cisco express and unity express using an AIM-CUE module.


we are planning on upgrading the software from version 2.3 to 3.1 i think it is. (one of the latest ones).


am i right in thinking we could get a spare aim-cue with the latest code on it and take a backup of the config/voicemail and then swap the modules and then once swapped then just restore the voicemails , configs etc..

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
paolo bevilacqua Fri, 09/18/2009 - 08:52
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Yes, however if you arrange for remote access, you can do that without touching hardware in 1 or 2 hours.

cmelbourne Fri, 09/18/2009 - 12:27
User Badges:

hey,


thanks for the update.


only done it once before and was a bit of a pain to be honest. i am going from release 2.1 to a fairly new release and said you need to do a clean install it says. does a clean install mean you lose the config and voicemails etc..?


Also, does the unity express software itself sit on the AIM-CUE then?

paolo bevilacqua Fri, 09/18/2009 - 12:31
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Yes clean install wipes out everything bust most often is the only thing that works. If you want to save aggravation hire me as I have all the patience of the world.


Yes the software sits on the flash disk of the CUE.


Please remember to rate useful posts with the scrollbox below.

Actions

This Discussion