09-19-2009 11:08 AM - edited 03-06-2019 07:48 AM
Hi Guys,
I have a 6509 Switch with single Sup 720 with basic configuration.But i m unable to break the password of this.I have tried all the methods which have mentioned on the cisco site.
Can anybody tell me that what could be the other method for breaking the password other than change the register value???
I am also trying to take the switch back on default settings but not successful till now.
Any suggestions will welcome & appreciate!!!
Regards,
Loyal2Cisco
09-19-2009 11:26 AM
If your config register has not been changed to ignore break, this link should help you:
HTH
Reza
09-19-2009 01:06 PM
Hi Reza,
I have done this same already.Because in my case, my sup engine is going in rmon mode continuously & after giving the boot command then it comes in user mode & asking for the password.
Thanx for ur hlp!
Regards,
09-19-2009 01:37 PM
Rohit,
To perform password recovery you need to do it when the right after the RP gains control of the console port. Please see the following link.
HTH,
Mark
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide