Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
312
Views
0
Helpful
1
Replies

Cisco 2801 with one BRI calls drops

etmarcof
Level 3
Level 3

‎09-20-2009 02:03 PM - edited ‎03-15-2019 07:49 PM

Hi,

I have one 2801 (IOS 14.4.15T8) with one BRI the problem is that many calls (inbound ou outbound) trough BRI gets dropped

My config:

network-clock-participate wic 0

network-clock-select 1 BRI0/0/0

interface BRI0/0/0

no ip address

isdn switch-type basic-net3

isdn overlap-receiving

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0

Usually in another configs i use static tei with no problems.

Layer 1 and Layer 2 are UP in BRI with no calls.

I see a lot of %MARS_NETCLK-3-CLK_TRANS in logging when calls are dropped layer 2 goes dow.

Any suggestions?

Best Regards

MC

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎09-21-2009 12:27 AM

Can you a try a different IOS ? like YB4 for example.

Note you or may not have static tei, ask telco.

0 Helpful
Customers Also Viewed These Support Documents