Lost config in nvram

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Mon, 09/21/2009 - 15:03
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Does it loose the config if, say, you reboot the switch too? Check the config register.

glen.grant Tue, 09/22/2009 - 03:17
User Badges:
  • Purple, 4500 points or more

I have seen it happen when you take a power hit , it then starts to reboot and takes another quick power hit . It may be something like that , you can test if you have downtime by just normally powering off and then powering on a couple of times , if it boots normally that may be whats happening but I am not sure there is any way around it unless its critical then you need to look at UPS's to keep that from happening.

YANGCCIE4 Tue, 09/22/2009 - 08:16
User Badges:


# dir flash


#sh flash

you may have a config file in your flash.

hope it help



This Discussion