MIB support for Openview

Unanswered Question
Sep 21st, 2009

2811 is supporting the attached mibs , but i m getting the error as below

The node is supposed to give response for "bridge MIB table". when we checked the o/p of

'snmpwalk <node>'

we are getting " dot1dBridge.dot1dBase.dot1dBaseNumPorts.0 : INTEGER: 0 "

This indicates that the nodes are not responding to "bridge MIB table".

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
cisco-blue Tue, 09/22/2009 - 03:59

the same thing happening with other mibs,for same device, in Openview server, what can be the problem

Joe Clarke Tue, 09/22/2009 - 07:04

No, there is no fix. The BRIDGE-MIB is just not supported on router platforms.


This Discussion