Hi, Thanks by your response. I can see that the SYS PWR led is blinking, then it stops for a moment and the led's light is switched on, then it switch off and it starts again the same process.

I think that the problem is the proper device and not the network.

Have you connected to the router via serial console for initial configuration ?

If you have not done that, whatever the LAN port does, is irrelevant.

The console via serial show nothing!!.

One moment...!, I have removed the Compact Flash and now it's working. The Compact Flash was inserted when I unpcked the product.

Sorry, I had a mistake, it not works either.

I have got to enter via serial. I can see the next error during the boot:

****** ERROR detected on PCI0 Bus

****** Try RESEATING all modules in the system

****** pci0_int_cause 0x00000200,

****** pci0_err_addr 0x00023801, pci0_err_cmd 0x0000000A

****** PCI Target Abort

Do what it's suggesting you, open it and reseat all modules.

If still trouble, return to vendor.

Yes, I will do it.

Greetings!!, Thanks for help me.

You're welcome, please remember to rate useful posts with the scrollbox below.