IDSM-2 Load Balancing VLAN Limitation

Unanswered Question

I am trying to configure a 6509 running 12.2(33)SXH4 to load-balance between (2) IDSMs in promiscuous mode.

It seems as though as I enter the command "intrusion-detection port-channel 60 capture allowed-vlan " with all the VLANs afterwards, there is a 255 character limit to the line. (I have a lot of VLANs). So I figure I can enter this command several times, and add the VLANs that didn't fit to the subsequent lines.


However, for every new command I enter, the only VLANs that "stick" to the config are the ones from the last command that was entered.


Seems there is a bug when adding VLANs to the "intrusion-detection port-channel" command.


Any ideas as to overcome this issue?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Tue, 09/22/2009 - 13:18
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Sorry I'm afraid you've meet a software limitation, contact the TAC to confirm but be ready to receive a reply like "WAD".

Actions

This Discussion