Is there a version of IP Communicator compatible w/ Windows 7?

Unanswered Question
Sep 22nd, 2009
User Badges:

I tried 2.1.3 on Windows 7. The app registers but I am unable to complete the dialing. I enter the digits but then pressing Enter or clicking Dial does nothing. Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jaime Valencia Tue, 09/22/2009 - 13:04
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

Try CIPC 7, i found a reference that someone got it working.

Right now there is not official support in any version for CIPC on Windows 7, development is probably working on this but might take a while


HTH


java


if this helps, please rate

mmedwid Tue, 09/22/2009 - 15:11
User Badges:

I tried loading 7.03. But I get the same symptom. Registers and I can enter digits. But in the end I can not send the digits. I will try to install in compatibility mode.

Nicholas Matthews Tue, 09/22/2009 - 18:26
User Badges:
  • Red, 2250 points or more

To anyone looking - there are known bluescreen problems with the CDP driver on windows 7. I don't know the exact cause to replicate it, but it's out there.


CUPC v8 should be supported for Win 7, but it's not supposed to be out for 6 months or so.



hth,

nick

mmedwid Wed, 09/23/2009 - 07:38
User Badges:

I tried installing with compatibility mode (using a few different compatibility modes) and this did not help. I notice when I run the communicator app I get error "Unable to initialize support for Cisco Emergency Responder service." What is that?

christopher.con... Fri, 01/15/2010 - 09:00
User Badges:

I use CIPC version 7.0.2.0 and it has been working fine for me on Windows 7 other than an error it throws up everytime I fire it up about an issue with the CER service.

Actions

This Discussion