Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
330
Views
0
Helpful
1
Replies

CSS and routing

snandigam
Level 1
Level 1

‎09-22-2009 11:00 PM

Please refer to the below config:

I am trying to reach vlan3. Can't at the moment. Is the below config valid?

ip route 0.0.0.0 0.0.0.0 172.24.17.241 1

!************************* INTERFACE *************************

interface e2

description "DMZ"

interface e3

bridge vlan 3

description "Internal"

interface Ethernet-Mgmt

description "Management"

!************************** CIRCUIT **************************

circuit VLAN1

ip address 172.24.17.103 255.255.255.0

circuit VLAN3

ip address 172.19.112.5 255.255.248.0

Labels:
0 Helpful
1 Reply 1

Gilles Dufour
Cisco Employee
Cisco Employee

‎09-24-2009 01:17 AM

yes this is correct.

Do a 'show phy' to see the status of the physical interfaces.

Make sure e3 is up.

Do a 'sho arp' to see if you have any arp entries on e3.

Try to ping a device one e3 from the css.

Finally, make sure the device on e3 uses the CSS as the default gateway.

Gilles.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents