- Gold, 750 points or more
(This question was copied over from the document area https://www.myciscocommunity.com/docs/DOC-10614)
Hi, I have a problem setting up a RV042 router to connect my LAN to intervet via DSL.
My internet connection with static IP adress works fine with a Linksys AG241 (192.168.0.200) in RFC1483 Routed mode. I have e new RV042 (192.168.0.7) in order to setup a VPN to give remote acces to our LAN to remote users.
I setup all IP information in RV042 (public adress + gateway+ DNS provided by my ISP, ie the same I use in the AG241) and put the AG241 in Bridge mode only in order to have the RV042 as default gateway for my LAN (ie 192.168.0.7 instead of 192.168.0.200).
In summuary setup page of RV042 ethernet port 1 connected to LAN is green. Internet 1 port connected to AG241 ethernet port is green. Traffic information in both ports is generated. But it is impossible to ping any public adress from diagnostic page in RV042. From the LAN all ping to WAN adress fail or tracert remain in 192.168.0.7 (RV042 adress). It seems RV042 doesn't route to the WAN.
Deas any body have solution to this problem.
I join a draft to show all connections