09-23-2009 08:56 PM - edited 03-04-2019 06:09 AM
Dear all,
i m struck off with the routing issue
Routing Table is like this
Destination Address Network Mask Next Hop Interface Index Type
0.0.0.0 0.0.0.0 10.194.208.190 1 remote
10.194.208.104 255.255.255.248 0.0.0.0 2 local
10.194.208.160 255.255.255.224 0.0.0.0 1 local
Arp table is shown below
Interface Index IP Address MAC Address Type
1 10.194.208.162 001b789dffce dynamic
1 10.194.208.164 001cc459f79e dynamic
1 10.194.208.166 001cc45b8ffa dynamic
1 10.194.208.179 001cc45b94d6 dynamic
1 10.194.208.180 001cc45b9800 dynamic
1 10.194.208.188 001b257b0100 dynamic
1 10.194.208.189 001b25799200 dynamic
1 10.194.208.190 00005e000102 dynamic
2 10.194.208.108 001cc45b8590 dynamic
2 10.194.208.109 001cc45ab80e dynamic
what is the new route i can give so that
10.194.208.180 can ping 10.194.208.108
, also want to know is there a possibility for forwarding the traffic in between interfaces of ME 3400
09-23-2009 09:44 PM
No routes required.
Both the network is already connected locally on your equipment. If your device supports and runs routing, 10.194.208.180 can ping 10.194.208.108 .
What device is this ?
09-23-2009 11:49 PM
Sorry i told wrong, i have to ping from 108 tp 180,
this is radware wsd 3000 load balancers
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide